Photos, descriptions and specs are for general reference and may vary- They may not depict actual Rental unit.
Cable Locator
Locators

Schonstedt MAC-51BX


 

The MAC-51Bx is the most cost-effective, all-purpose locating system on the market. It consists of a magnetic locator, similar to the most popular GA-52Cx model, and a null-over-target pipe and cable locator capable of locating on two frequencies: 571Hz and 82.5kHz.
In the LO and HI modes, the receivers audio signal provides a sharp null when its tip is directly over the target. In the MAG mode (no transmitter required) the audio signal peaks when the receiver's tip is over the target. You can trace the 571 Hz LF signal conductively applied to any continuous metal conductor up to 4000 feet.
The receiver's on-the-fly mode-changing feature lets you locate a complete break using the LO mode, and then continue on to trace beyond the break in the HI mode, or trace a metal pipe joined with non-conductive gaskets.
The MAC-51Bx by simultaneously transmitting 82.5 kHz (HF) and 571 Hz (LF) signals lets you select and compare received audio signals from both frequencies along with magnetic information without having to return to the transmitter.
Transmitter Inductive Mode (HF only)
Induction is achieved by placing the transmitter over the target cable/pipe or by using the optional Inductive Signal Clamp. It's the easiest and quickest way to applying a trace signal that is strong enough for tracing most lines. The trace signal generates an alternating magnetic field around the cable which induces a signal into the receiver's cable sensor. A sharp null in the audio signal between the two peaks occurs when the receiver's tip is directly over the cable.
Transmitter Conductive Mode
If an exposed section of a target gas or water pipe is accessible, conductive coupling is the most reliable method for applying the trace signal. This mode has to be used to apply both HF and LF frequencies so that you can use all three features on-the-fly. Providing a good electrical contact between the clip and the conductive portion of the target line by removing rust or paint before attaching the clip is very important.
Magnetic Locating Mode
Only the MAC-51Bx receiver is required when operating in the magnetic mode. Just set the Mode switch to MAG, the Gain control to mid-range, and you're ready to locate underground ferrous pipes, water meters, water valves, and property markers - or anything that has a magnetic field including the 50/60Hz electro-magnetic field generated by energized power lines.
Features:
Two active frequencies for pipe, cable and line tracing
Passive operation for locating iron and steel targets and energized 50/60Hz power lines
Inductive and conductive signal coupling
Extra Heavy Duty Clips and Cable
Five discrete sensitivity settings
Receiver supplied with two environmentally friendly 9-volt lithium batteries
Piezoelectric Speaker
45º Depth Measurement
Patented HeliFlux Sensors

 

Specifications:
Receiver
Operating Voltage: 9V (2 alkaline or 2 lithium batteries)
Battery Life: 60hrs, alkaline (on & off usage @ 70ºF), 120 hrs, lithium (on & off usage @ 70ºF)
Audio Output: Approx. 40 Hz idling tone from speaker
Frequency of pulsing tone (increases or decreases) with signal intensity
Weight: 2.64 lb. (1.20 kg.)
Operating Temp: -13oF to 140oF (-25oC to 60oC)
Overall Length: 42.3 in. (107.4 cm.)
Waterproof Length: 34.5 in. (87.6 cm.)
Nominal Sensor Spacing: 20 in. (50.8 cm.)
Transmitter
Operating Voltage: 12V (8 alkaline C-Cell batteries)
Battery Life: 60 hours (on & off usage @ 70ºF)
RF Output: 82.5 kHz modulated at 382 Hz, pulsed at 4.4Hz
571 Hz Pulsed at 4.4 Hz
Audio Indicator: 2.58 kHz pulsed at 4.4 Hz
Weight: Approx 5.5 lb. (2.5 kg.)
Operating Temp: -13oF to 140ºF (-25ºC to 60ºC)
Overall Size: 43.5 in. x 7 in. x 5 in.
(110.5 cm x 17.8 cm. x 12.7 cm.)
For additional information on this product please call us at 877-289-7368

Schonstedt XTpc Pipe & Cable Locator


The XTpc features simple one hand operation with all controls in easy reach of your thumb.The controls and the LCD display area are large and easy to understand. Clear direction arrows facilitate easy locating and foolproof centering.

The XTpc operates in passive mode, three different active modes (conductive, inductive and clamp), and a sonde mode.

This extremely versatile locator also features single button depth calculation. Simply place the receiver directly over the target and press the depth button.

XTpc Specifications

Receiver

Operating Frequency: 82kHz or 33kHz
Battery 9V Alkaline single battery
Battery Life: 18 hours intermittent use
Audio Output: 10 - 3000 Hz determined by signal strength
0 - 70 db SPL (Sound Pressure Level), volume controlled
Weight (incl. batteries): Under 2.8 lbs
Operating Temp: -4°F to 140°F (-20°C to 70°C)
Dimensions: Closed:
17.5 in x 3 in x 8.5 in
(44 cm x 7.6 cm x 21.5 cm)

Extended:
27.7 in x 3 in x 8.5 in
(70 cm x 7.6 cm x 21.5 cm)
Max. Depth Capability: Approximately 19' (5.8 m)

Transmitter

Operating Frequency: 82kHz or 33kHz
Output Power: Maximum 1-watt allowed under FCC at 82kHz; 1.8-watt at 33kHz
Battery Type: Rechargeable NiMH pack (7.2V)
Battery Life: 8 hours intermittent operation
Charger: Smart charger powered by AC supply or vehicle supply
Outputs/Inputs: Circular "smart" connector to:
1) Inductive antenna
2) Inductive clamp
3) Conductive clips
4) Battery charger
Weight (incl. batteries): Under 1.5 lbs
Operating Temp: -4°F to 140°F (-20°C to 70°C)

 


Daily* Weekly* Monthly*
$69.00 $207.00 $517.50
* "Rent Now" is not a reservation or a guarantee of availability. An Associate will contact you once your request has been submitted. Equipment Makes & Models shown may vary from the actual Rental unit you receive.

Back